FEC AFC1200 - Manual (Page 16)

)(& ,QF
4.7.3 Bank Select Table
SEQ OUT 4 DATA 7
SEQ OUT 3 DATA 6
SEQ OUT 2 DATA 5
These four signals will output, as
appropriate, when the fastening sequence
reaches a step that has an [OUT] out port
command inserted. Used to provide
sequence operation status out to the PLC. SEQ OUT 1 DATA 4
SPARE DATA 3
SPARE DATA 2
SPARE DATA 1
Outputs when System is in Program mode. PROGRAM DATA 0 ON OFF 2
SEQUENCE 2 DATA 7
SEQUENCE 1 DATA 6
Output confirmation of SEQUENCE SELECT
0~2 (Pins 9~11) input selections. SEQUENCE 0 DATA 5
Output after a START signal is received, and
active until the fastening cycle is complete
and the READY signal is output. BUSY DATA 4
Output when the system is in READY
condition. Indicates system is ready to
operate, and inputs are enabled. This signal
is inactive (off) when the BUSY output is
active (on). READY DATA 3
Output when an Abnormal condition occurs,
this signal indicates that the System has
detected an internal fault, and can no longer
proceed. Details regarding an Abnormal
condition may be output to an Axis Unit
display, if relevant, or out to the System
monitor. An Abnormal condition must be
corrected before the System will resume
normal operation. ABNORMAL DATA 2
Output when the fastening result is a
ACCEPT. Indicates all spindles are within
fastening limits. This output remains active
until the START signal or RESET signal is
input. ACCEPT DATA 1
Output when the fastening result is a
REJECT. Indicates one (1) or more spindles
has failed fastening limits. This output
remains active until the START signal or
RESET signal is input. REJECT DATA 0 OFF OFF 1
DESCRIPTION
NAME OF
SIGNAL
BANK DATA
PINS 23~30
0
PIN 21
1
PIN 22
BANK
#
Chapter 4: System Setup and Wiring User Console Version A3.53
Page 4-16