FEC AFC1200 - Manual (Page 22)

)(& ,QF
B. Fastening Sequence Selection and START signal input (Main Unit)
SEQUENCE SELECT 1
SEQUENCE SELECT 2
SEQUENCE SELECT 0
BANK SELECT 1
BANK SELECT 0
BANK DATA 6
BANK DATA 7
BANK DATA 5
START
OFF
OFF
ON
50 ms
50 ms
Selection of SEQUENCE 2
BANK 1 is required to enable
These outputs echo SEQUENCE
(BANK 1) SEQUENCE 0
(BANK 1) SEQUENCE 1
(BANK 1) SEQUENCE 2
SEQUENCE 0~2 outputs.
SELECT 0~2 inputs (pins 9~11)
when BANK 1 is active
OFF
OFF
(PIN 9)
(PIN 10)
(PIN 11)
(BANK DATA 7, BANK 1).
(PIN 21)
(PIN 22)
(pins 21~22).
Reference Section 4.7.2 for
SEQUENCE 1~8 selections.
Reference Section 4.7.3 for
BANK 1~4 settings.
These signals will not output for
at least 50 milliseconds after the
SEQUENCE SELECT 0~2
input signals are received.
The START signal may be input
following SEQUENCE 0~2 output.
A minimum delay of 50 millisecond
is required between the output of
SEQUENCE 0~2 signals and the
START signal input.
Default setting:
BANK SELECT 0 & 1 = OFF
OFF
OFF
ON
ON
OFF
OFF
OFF
FIG. 4-7-7b Example of Sequence # 2 Selection
Chapter 4: System Setup and Wiring User Console Version A3.53
Page 4-22