FEC AFC1200 - Manual (Page 2)

)(& ,QF
9.0 Alphabetical List of Abnormals
9-7 9.2.2 Presetting Error
9-17 9.4.4 Preset Data Abnormal
9-12 9.3.3 Preset Spindle Does Not Exist
9-11 9.3.2 Preamp EEPROM Read Abnormal
9-21 9.4.10 Preamp EEPROM Read Abnormal (Axis Code "A3")
9-14 9.3.7 Parameter Set Abnormal
9-17 9.4.3 Offset Check Abnormal
9-8 9.2.5 No Upload Data
9-9 9.2.8 No Statistics Data
9-18 9.4.6 Motor Over Temperature Abnormal
9-4 9.1.2 Keyboard Failure
9-25 9.5.1 Input Error
9-23 9.4.13 Input Power Over Abnormal
9-21 9.4.9 Full Scale Torque Over Abnormal
9-8 9.2.3 Fastening
9-6 9.1.6 Failure To Fasten
9-18 9.4.5 Encoder Angle Pulse Abnormal
9-9 9.2.7 EEPROM Write Error
9-22 9.4.12 Dual Port RAM Abnormal
9-5 9.1.5 DOS Boot Failure
9-25 9.5.2 Data Error
9-5 9.1.4 CRT Failure
9-12 9.3.4 Controller EEPROM Write Abnormal
9-14 9.3.9 Console Dual Port Ram Abnormal
9-4 9.1.1 Communications I/F Abnormal
9-10 9.2.10 Communications Time Over
9-7 9.2.1 Command Error
9-4 9.1.3 CMOS Power On Self-Test (POST) Failure
9-16 9.4.2 Cal Check Abnormal
9-24 9.4.16 Axis Unit Lockout (actual lockout - not a display)
9-26 9.6 Axis Unit Abnormal Codes
PAGE # SECTION # MONITOR (CRT) DISPLAY "ABNORMAL"
MESSAGE
Chapter 9: Troubleshooting
Page 9-2