Fairbanks NexWeigh - Manual (Page 19)

04/14 19 51216 -- Rev. 6
Section 4: Programming Configuration
4.1. OVERALL STEPS
Follow these steps to program the NexWeigh Instrument.
A. Configure the NexWeigh Instrument operating parameters.
B. Calibrate the NexWeigh Instrument.
C. Set up the NexWeigh Instrument options.
4.2. INTRODUCTION
•
The program group is shown and accessed in steps.
• Each program group may be entered and modified, or skipped to the next group.
•
At each step, a word or abbreviation displays, indicating the parameter to be set.
•
Each step then may be viewed or modified.
•
At the end of programming a SAvE prompt will be displayed.
•
Press PROGRAM/ENTER to SAvE and exit or scroll to CAncEL to disregard
changes made.
The following is a rendering of the four programming groups. Pressing
OVER/UNDER/NEXT or TARE will scroll through the choices listed.
PROGRAM/ENTER will enter the program steps in a particular group. See chart
in Sec 4.3 for full details of front panel pushbuttons for programming mode.
SEtuP ConFiG APP CAL donE
SAvE CAncEL