General Tools and Instruments LTH8809DL - Manual (Page 7)

-After pressing "SET" key to enter start
mode setting, there are 4 start modes
for you to choose." ","P2" show on
the screen.
Repeat :
'rEp' displays on the bottom of the
monitor. Repeat means the logger
will automatically record again once
the memories are uploaded to PC.
Key start:
'hEy' displays on the bottom of the
monitor. Key start means the logger
will start to record when you press
the start/stop key > 2 seconds.
Immediately:
' ' displays on the bottom of the
monitor. Immediately means the
logger will start to record right away
after you saving the setting.
-Press "Up" or " Down" to choose the
sample point value.
-Press "SET" to save and return to P1.
or press "MODE" to escape without
saving the value.
NOTE: " " in above diagram means
K. Please refer to page 18 for
reference.
Start Mode
Schedule
'SCh' displays on the bottom of the
monitor. Schedule means the logger
will start to record from the date & time
you preset in P3.( Page 7)
8808
6
- In Pts (P1) mode, press "SET" to enter
this mode and to change the value.