General Tools and Instruments LTH8809DL - Manual (Page 9)

Second set
'SEc' displays on the top( 8809/07) or
middle (8808/06) of the monitor.
-The values for above 6 parameters
will display on the bottom of the monitor.
-Press "Up" or " Down" to adjust the
setting values.
-Press "SET" to save the setting and
enter next parameter.
-Repeat above steps to finish the whole
setting.
-Press "MODE" to return to main menu
if you don't want to save the setting.
NOTE: While in logging mode, press
START/STOP key >2 seconds to stop
logging. The parameters only could
be set while the meter is not in logging
mode.
NOTE: While in logging mode, press
SET key could enter setting
mode to "VIEW" the setting.
Y-M-D
Y-M-D
Y-M-D
H:M:S
H:M:S
H:M:S
8
8808