Gentec-EO HP - Manual (Page 12)

Version 2.2
8
HP Series Instruction Manual Gentec Electro-Optics Inc. All rights reserved
- The measured power is calculated as follows:
Measured power [W] = (output voltage [V] - zero level voltage [V]) / sensitivity [V/W]
= 1000 x (Vout [mV] - Vzero level [mV]) / sensitivity [mV/W]
2.2 WITH PC-HP
This section describes in detail the first group of menus essential to the PC-HP operation. The
display menu lets you view the status and your measurement in various ways. Use the settings
menu during setup to set the best parameters for the measurement task at hand. It provides the
flexibility to accommodate a wide variety of measurement conditions.
The water temperature and flow rate are displayed in real-time at the bottom of the interface
.
FIG. 2-1 PC-HP INTERFACE