King Kooker Jet and Combination Burners - Manual (Page 10)

94/90tKd Assembly
see below illustration for part identification.
Also included - 6 bolts, 8 lockwasher and 8 nuts
1. Place top frame of unit onto bottom frame of unit as per Figure 3 above. Make sure the lighting hole
located on the windshroud on the top frame is installed facing away from the jet burner, to the
outside of the cooker frame. Align holes located on top and bottom frames. Insert four bolts through
holes in top and bottom frames of unit. Wrench tighten with supplied lock washers and nuts.
2. Attach wheels to the bottom frame of the unit as pictured using the supplied axels, lockwashers and
nuts.
3. Attach the cylinder heat shield to the outside of the top frame as pictured using two bolts. Wrench
tighten with supplied lockwashers and nuts. See below Figure 4.
4. Insert threaded ends of cylinder collar into holes located on top frame as pictured (the two tabs
should point down.) Wrench tighten with supplied lockwashers and nuts. See above Figure 4.
5. Attach tank ring to the bottom frame as per Figure 3 using the U Clips which are welded to the
outside of the frame.
10
Bottom Frame
Top Frame
Jet Pipe
Wheels, Axles, Lockwashers
and Nuts
Tank Ring
Cylinder Collar
Windshroud
Lighting Hole
Cylinder Heat Shield
View of Attachment
From Inside of Cart Frame
Figure 3
Figure 4