King Kooker Jet and Combination Burners - Manual (Page 16)

lIghtIng And operAtIng InstructIons
the cooKer must not be lIt untIl the precedIng
plAcement InstructIons hAVe been completely Followed.
For models wIth AdjustAble regulAtors
1. If your Jet Burner has a baffle over the jet tube, turn it away from the jet tube.
2. Make certain that the regulator control is turned to OFF by turning it counterclockwise until it reaches the stop.
3. Open cylinder control valve by turning it counterclockwise as per the diagram (Figure 2).
4. Hold a multipurpose lighter as per Figure 4 or paperbook match as per Figure 3 over the jet pipe. Turn the regulator
control toward the ON position until ignition occurs. Turning the regulator control clockwise increases the gas
pressure to the burner and hence the flame size (Figure 2).
When lighting the cooker, if ignition does not occur in 3 to 5 seconds, turn the regulator and cylinder valve off. Wait
5 minutes for gas to disperse. Repeat procedure. Refer to Figure 5 for proper flame emission.
5. If your jet cooker has a baffle, turn it to desired position over the flame using a noncombustible cooking utensil. The
purpose of the baffle is to spread the flame across the bottom of the pot. When trying to reach a boil with water using
a large stock pot, do not use the baffle.
6. Always monitor the flame throughout the cooking process. If at any point in the cooking process the flame is
accidentally extinguished, immediately turn the regulator and cylinder valve OFF. Wait 5 minutes for gas to disperse
and relight the cooker according to the lighting instructions. (#1 - #5) in this section.
(Figure 1)
(Figure 2)
(Figure 4)
(Figure 3)
(Figure 5)
20 lb. LP
Gas Cylinder
pAper booK mAtch multI purpose lIghter
16
neVer put hAnds or FAce dIrectly oVer burner whIle lIghtIng
or whIle the ApplIAnce Is lIt.
(.61m)
* Model may
vary from
picture
turn cylinder handle
toware on
(counterclockwise)
next
turn regulator control
toward on
(clockwise)
AdjustAble regulAtor