King Kooker Jet and Combination Burners - Manual (Page 11)

11
6. Locate the three separate heat plate pieces. Lay the plates on a flat surface as shown in Figure 5.
Place the rounded inner edge of one plate against the vertical jet pipe located on the bottom
frame. The bottom of the plate should be located above the the “bent” prongs when installed (3
“bent” prongs welded to side of jet pipe.) The plate will fit around the “bent” area of the prong
using the cutouts provided on the plate. Repeat procedure with the second plate. Align the bolt
holes of the first and second plates and attach with bolt, lock washer and nut. Repeat procedure
with the third plate. Tighten all bolts/nuts. Reference Figure 6 for picture of heat plate assembly.
7. Install casting into top frame by following the instructions below -
a. Remove top nut from casting bolt. Leave bottom nut attached and tightened (if applicable).
b. Insert casting bolt through the hole drilled in flatbar that is welded to the base of the
windshroud.
c. Reinstall nut to casting bolt. Wrench tighten. Make sure casting is pointing straight up and is
sturdy.
d. See below Figure 7 for picture of casting assembly.
Bottom Frame
Top Frame
Flat Bar
Casting
Windshroud
Heat Plate
Assembled
“Bent”
Prong
Jet Pipe
Figure 5
Figure 6
Figure 7
“Bent” Prong
Cutouts