Ransburg No. 2 Process Handgun Electric Motor - Manual (Page 19)

No. 2 Process Electric Motor Version - Installation
Ransburg
15 AH-13-01.1
† When the radius portion of the brush
plastic tip is gone, the brush will need to
be replaced soon.
Figure 10: Brush Tip New and Worn
PAINT
A proper paint mixture is essential to the electro-
static operation. Due to the method of electro-
static atomization the viscosity and conductivity
levels of the paint are important to ensure proper
application. Paint test equipment such as the
test assembly (76652-03) for testing paint elec-
trical resistivity, may be purchased through your
Ransburg distributor. (See “Paint and Solvent
Specifications” in the “Appendix” section of this
service manual.)
Most paint suppliers may be of assistance in
pre-adjusting the paint for proper electrostatic
sprayability.
W A R N I N G !
NOTE
† When the gun switch is ON, the bell will
be rotating and high voltage will be activated.
Steps MUST be taken to ensure grounding of
personnel and equipment for safety. Electri-
cal shock may occur if the equipment and/or
personel are NOT grounded.
Item #
1
2
BRUSH TIP NEW AND WORN
(Figure 10)
Description
New Brush Tip
Worn Brush Tip