Ransburg No. 2 Process Handgun Electric Motor - Manual (Page 30)

No. 2 Process Electric Motor Version - Maintenance
Ransburg
26 AH-13-01.1
Item #
1
2
3
FLUID FILTER REPACEMENT
(Figure 16)
Description
Filter Front Housing
Filter Rear Housing
Paint Filter Element
Item #
1
2
3
FLUID FILTER REMOVAL
(Figure 15)
Description
Fluid Hose
Fluid Filter
Fluid Inlet Fitting
Filter Cleaning or Replacement
(Refer to Figure 15)
Disconnect the fluid hose assembly from the filter
assembly. Hold the filter assembly rear housing
with a 3/4-inch open end wrench and with a 5/8-
inch open end wrench turn the fluid hose nut in a
clockwise direction (left hand threads) to remove
the fluid hose.
Disconnect the filter assembly from the gun as-
sembly. Secure the hose connector assembly with
a 5/8-inch open end wrench and with a 3/4-inch
open end wrench connected to the filter assembly
nut , turn the nut clockwise and remove the filter
assembly.
Figure 15: Fluid Filter Removal
Figure 16: Fluid Filter Replacement
1. Secure the rear housing of the filter assembly
in a vise and with a 3/4-inch wrench connected
to the front housing, remove the front housing
(right hand threads).
2. Remove the paint filter element from the rear
housing .
3. If a new paint filter is to be installed, clean
the front housing and rear housing using the
appropriate solvent .
4. If the same paint filter is to used, wash the
paint filter, front housing, and rear housing
in solvent. Use a bristle brush to clean paint
from the metal disk of the paint filter.
5. Secure the rear housing in a vise. Place
the paint filter element into the rear housing
metal disk first.
6. Turn the front housing onto the rear housing).
With a 3/4-inch open end wrench, tighten the
front housing to the rear housing.
7. Connect the filter assembly to the applica-
tor assembly and the fluid hose to the filter
assembly.