Ransburg No. 2 Process Handgun Electric Motor - Manual (Page 41)

No. 2 Process Electric Motor Version - Maintenance
Ransburg
37 AH-13-01.1
Use of LSCH0009 Dielectric Grease
in No. 2 Handgun
Misuse of the LSCH0009 dielectric grease inside
the No. 2 Handgun can cause premature failure
of the electric motor. Dielectric grease should
only be used as a filler (displacement of air) to
suppress high voltage corona. Dielectric grease
should only be applied to the following parts:
Exposed high voltage cable of the gun end
and the power supply end of the 19370-xx high
voltage cable
Inside the white 6204-00 high voltage resistor
housing
On the inside and outside of the 2842-01 (525
megohms) high voltage resistor
The use of LSCH0009 dielectric grease or any
other lubricants on any components associative
with the electric motor, drive shaft assembly, and
ground circuit is forbidden. Due to these areas
direct contact to the D.C. motor, lubricants can
migrate into the motor and cause it to fail. Dielectric
grease SHOULD NOT be applied to the following
areas of the No. 2 Handgun:
7225 drive shaft assembly
4175-01 shaft (ground) resistor (10 G Ohms)
Components of the shaft seal/ bearing assembly
at the front end of the drive shaft
Special care is and has always been taken during
manufacturing of the gun to apply the dielectric
grease only to those areas noted. Gun failure
associated with misuse of dielectric grease will
not be covered under warranty.
•
•
•
•
•
•