Ransburg 9060 HV P.S. Electric Motor 80102-21X - Manual (Page 20)

9060 for No. 2 Process Handgun - Installation
15 CP-13-03.2
NO. 2 PROCESS HAND-
GUN TRIGGER SIGNAL
The No. 2 Process Handgun (80102-21X) uses
a relay board (P/N 76649-00) to provide the
trigger signal output. The listed relay board is
mounted on the top of the cascade casing
inside the 9060 Controller chassis. When the
No. 2 Process Handgun on-off switch is turned
on, it activates the relay on the board which
connects the trigger input (J3-5) to ground.
This signal causes the PC mainboard to turn on
the high voltage. For information on the
replacement and wiring of a relay board, see
the “Replacement Procedures” in the Mainte-
nance Section of this Manual.
N O T E S