Ransburg 9060 HV P.S. Electric Motor 80102-21X - Manual (Page 25)

9060 for No. 2 Process Handgun - Operation
CP-13-03.2 20
N O T E S Boot Fault (bF)
This fault will occur during the start-up se-
quence if the No. 2 Handgun on-off switch is in
the on position. It is designed to prevent
immediate triggering after start-up as the unit
should be allowed to enter the “ready” state
prior to being triggered. This fault also prevents
the high voltage from being fired if the micro-
processor resets. For additional information,
refer to the Fault Troubleshooting Section.
Figure 17: Boot Fault Display