Ransburg 9060 LV Cascade Controller 80131-XXX - Manual (Page 12)

9060 Cascade Low Voltage Controller - Introduction
7 CP-13-07.2
INTRODUCTION
GENERAL DESCRIPTION
The Ransburg 9060 Cascade Low Voltage
Controller
(80131-XXX) is used to provide
high voltage for electrostatic application
equipment. It uses a combination of proven
high voltage generation technology and
microprocessor-based control. It uses a
variable voltage output to drive an external
cascade that amplifies the voltage to a high
kV level. It also uses current feedback
information to maintain the desired set point.
The processor circuitry provides the maximum
in applicator transfer efficiency, while main-
taining the maximum safety.
The 9060 Controller provides the selection
and adjustment of set point values is per-
formed from the controller front panel. The
trigger of the HV is initiated by the airflow
switch built into the controller which senses
airflow triggered by a standard handgun.
SAFETY FEATURES
When used with the appropriate applicators
and cascades, the Ransburg 9060 Cascade
Low Voltage Controller provides maximized
operational safety. The protections include
detection of Ground Faults, Cable Faults,
Feedback Signal Faults, Overvoltage, and
Overcurrent. The microprocessor circuits
provide a controlled output load curve, which
limits the high voltage output to safe levels
while monitoring control and feedback signals
for unsafe conditions. Maximum operational
safety is obtained when the correct applicator
settings are used and when safe distances
between the applicator and target are ob-
served and followed. The maximum efficiency
of the low voltage controller is based on load.
DISPLAYS
The front panel displays the high voltage set
point as well as a reading of gun current out-
put. The gun current is derived from feed-
back signals in the low voltage cable be-
tween the controller and the cascade.
Figure 1: 9060 Cascade Low Voltage Controller
Part #: Description
80131-21X Vector R70AS Handgun
80131-31X Vector R90AS Handgun
80131-41X Vector AA90 Handgun
80131-51X Vector R90AS Waterborne Handgun
The 9060 Low Voltage Controller (80131-
XXX) is available as follows: