Ransburg AquaBlock2 A12148-XX - Manual (Page 35)

AquaBlock 2 - Maintenance
30
Reassembly of Female Disconnect
(Continued)
Disassembly of Male Disconnect
Inspect the white face seal in the groove on
threaded side of the body. If there is no damage,
do not replace. To replace, pry out of groove. Do
not damage threads or seating surfaces. Using
a snap ring pliers, remove snap ring holding seat
assembly into the body. Remove piston assembly,
spring, and spring retainer from the threaded end.
Thoroughly clean all parts and make sure they
are dry before assembling.
Inspect the male body front face and the interior
seating face behind the front face. If any damage
is observed, the body needs to be replaced.
Inspect the rubber of the piston assembly. Any
pits, scratches, tears; replace with new.
Insert piston into the body followed by the spring
and spring retainer. The small end of the retainer
goes into the spring. Reinstall the snap ring. Make
sure it is fully into the groove.
Figure 8: Male Disconnect
BODY
PISTON ASSEMBLY
SPRING
SPRING RETAINER
SPRING CLIP
VISUALLY INSPECT THIS AREA TO ENSURE
THAT THERE ARE NO NICKS OR DAMAGE.
A12098-00
A12099-00
A11392-00
79001-50
0-RING
A12097-00
INSPECT FOR PITS, SCRATCHES
AND TEARS
SEAT
A12122-00
LN-9902-00.3
Ransburg