RECON 26417 Bed Rail Light Kit - Manual (Page 7)

Take one string of Recon bed lights and tape the pods to the holes with lights facing
inward. This gives the correct spacing and allows you to fold and zip-tie the excess
wiring for a tidy install.
Insert recon bed lights one at a time until each reaches their respective cut-out. Again if
your careful and cut the holes correctly the pods will fit snug in the opening. I later
drilled small holes opposite each cut-out and drove a machine screw through to contact
the backside of the light pod to prevent it from falling out. Additionally I applied some
epoxy around the cutout contacting the light pod.