RECON 26417 Bed Rail Light Kit User Manual
Page 8
A small hole was drilled in the aft end of the tube to allow the power cord out since the
ends will be blocked with the well nuts. Insert the tube into the bracketed well nuts and
tighten until tube is snug and does not spin freely. Adjust the angle of the lights so that
they point towards the center of the truck bed (best done at night to get optimal lighting
situation).
ELECTRICAL HOOK-UP
I wanted the lights to be operated ONLY by a toggle switch when keys were in the
ignition and not activated by auxiliary function like the tailgate opening, or the third
brake light. So I tapped off the factory hitch plug. This option allows total control of the
lights. Choose what method you wish. The power cord was run up thru one of the holes
created by the clips in the plastic bed rail cap and run back towards the rear tail light.