RECON 264150 Backup Projector Lamps DIY - Manual

Page 1
In This DIY We Will Show You How To Install Recon Backup Lamps (part # 264150 To Run On A Separate Switch & In Reverse.
Please Note, There Are Many Ways of Installing These Lights, Including Wiring Methods, Wiring Connectors, And Other Variables
_________________________________________________
- Go Over The Parts Included In The Kit That You Received – Confirm All Items Are In The Box.
You Should Have
- 2 Projector Lamps
- 1 Switch
- Wire Harness
________________________________________________________
Tools Required:
A Good Assortment of Hand Tools are Recommended, Required Hand tools Are As Followed:
- Drill
- Drill Bit Set
- Phillips Bit
- DC Voltage Meter
- Screw Drivers Phillips & Flat Head (Small Flat Head)
- Wire Strippers & Crimper's
- Choice of Connectors +/- Soldering Tools
- Electrical Tape