RECON 264150 Backup Projector Lamps DIY - Manual (Page 2)

Page 2
The Following Are Additional Components You'll Need To Get To Install Exactly As Indicated On These Instructions:
• Insulated Terminal Connectors
• Heat Shrink Tubing
• Stranded LV Wire (Spec'd At Least At 20 Amp)
•
30A Relay (Auto 12V)
• 1N4005 Diode
• 4 Stainless Bolts
• 4 Stainless Washers
• 4 Stainless Lock Washers
• 4 Stainless Nuts
• At Least 15ft of Wire Loom
______________________________________________________________________________
Projector Layout & Drilling.
It Is Not Required, But Disconnecting Your Batteries Negative Cable Is Recommended
Figure Out Where You Want To Mount Your Backup Lamps