RECON 264150 Backup Projector Lamps DIY User Manual
Page 7
Advertising
Page 7
•
Connect The Strip of Wire Connected To The Diode To The White Wire From Your Switch (This Will Be The 86 Terminal On The
Relay)
•
Run A Power Wire From Your Battery (+) and Install A 15-20AMP Fuse & Holder. (This Will Be The 87 Terminal On Your
Relay)
•
Connect The Power Wire That Is Going To The Recon Projector Lights. (This Will Be The 30/51 Terminal On The Relay)
•
Now Run A Adequate Ground Wire (This Will Be 85 Terminal on The Relay)
_________________________________________________________________
Tuck In All Your Wires, And Test The System.
At This Time Your Projectors Should Work Off Of The Switch & While Vehicle Is In Reverse. You’re Done!!!
Advertising