RECON 264150 Backup Projector Lamps DIY User Manual
Page 4
Advertising
Page 4
Tie Into Backup Lamps & Wire Projectors
•
Locate The OEM Wires Going To Your Tail lamp - Peal The Wires Out From The Loom
•
With A Multi Meter, Find Out Which Wire Powers Your Reverse Light Bulb
•
Cut Out A Section of Wire To Solder To & Solder To The New Wire Labeled "Reverse Light"
•
Tape and Cover Splice With Loom
•
With The Supplied Wire Harness (The One That Came With The Recon Projectors) Cut The White and Black Wires Designed To
Wire Up The Projectors - Approx. Half Way.
•
Loom The Harness & Connect Harness Power To The Newly Ran Wire Labeled "Backup Lamps"
* To Protect Connectors From Weathering - Be Sure To Use Heat Shrink Connectors - Or Heat Shrink Tubing.
Advertising