RECON 264150 Backup Projector Lamps DIY - Manual (Page 5)

Page 5
•
Connect Harness To Projectors
• Connect Harness To A Solid Ground (To Prevent Rusting, It Is Recommended To Spray Terminals With Rust Blocking Agent)
• Finish Running Loom Around Wires, Tape And Zip Tie Everything Up.
The Rear Is Now Complete.
Onto The Front Layout & Wiring Switch - ** This Is The Wiring Diagram To Use While Wiring Your Setup
It Is Now Time To Wire The Front, You Will Need To Find A Location To Run Through Your Firewall. Either Drill Through Your