SKC Limited EPAM-5000 - Manual (Page 37)

Location Codes
Introduction The EPAM-5000 assigns a location code called tag number to each sampling
sequence. The active location is indicated in the Data Record Screen (See
figure 3.10).
Maximum
location codes The EPAM-5000 can store a total of 21,600 data points, which can be
distributed into a maximum of 999 locations.
Assigning
location codes The location code assigned to the site is determined by the memory storage
type selected in step number three of the sampling process (page 3-9).
Use the table below to identify the location code being used.
Data storage type selected... The SKC EPAM-5000 Assigns...
Continuation The Next Consecutive Value as the
Location Code.
Example: If data was previously stored
in Tag #001 and #002 the data being
collected will be stored in Tag #003.
Overwrite 001 as the Tag Number and all previously
stored data points in all locations are
erased.
3 - 12