SKC Limited EPAM-5000 - Manual (Page 68)

5 - 10
Battery Maintenance,
Continued
Removing and
replacing the
battery pack The battery pack can be removed and replaced whenever necessary.
Note: The battery of the EPAM-5000 can be recharged outside of the
instrument.
Removing the
battery Follow the steps in the table below to remove the battery pack.
Step Action
1 Loosen the four retaining pem screws from the top plate of the
EPAM-5000.
NOTE: These are special inserts and the screws are attached by a
spring to tighten push the screw down and turn to loosen turn the
screw and it will pop on the spring DO NOT pull the screw
because you will break the spring and be unable to secure your
battery pack.
2 Slide the battery plate out of the unit.
3 To re-install reverse above proceeding
Figure 5-3. Diagram of battery being removed from EPAM-5000.
Continued on next page