SKC Limited EPAM-5000 - Manual (Page 38)

Reviewing Stored Data
Introduction
The EPAM-5000 provides extensive capabilities for reviewing internally
stored data and statistics on the LCD or downloading to a PC using
DustComm Pro Software (Chapter 4).
LCD display The following information can be displayed on the LCD.
Display Description Tag #
Date Date of sampling.
Start Time sampling began.
Stop Time sampling was terminated.
Time Time of occurrence of reported statistic.
MAXIMUM Sample Highest concentration of dust particles.
MINIMUM Sample
Lowest concentration of dust particles.
T.W.A. Time weighted average concentration of dust
particles.
Elapsed Elapsed time of the time weighted average.
S.T.E.L. Short-term exposure limit.
Viewing data
on the LCD Follow the steps in the table below to review stored information and statistics.
Step Action
1 Select Review Data.
2 Select Statistics.
3 Determine your next step using the table below.
If... Then the...
Memory holds data points in
other locations.
The Scanning Memory
Screen displays. Go to step 7.
Memory has been cleared of
all data points.
No Data Recorded.
4 Select the Location using the table below.
To review... Select...
A different Location New Tag XXX and go to step
7.
Continued on next page
3 - 13