IAI America RCP2CR-SS8C - Manual (Page 73)

65
9. Maintenance and Inspection
8) Install the pulley assembly.
䈄 Align the angles of projections and depressions on
the couplings.
‡7LJKWHQWKHKH[DJRQVRFNHWKHDGVFUHZV
0îSFV XVLQJDQ$OOHQZUHQFKRI
2.5 mm across flats.
Align the angles of projections and depressions.
9) Loop the belt over the pulleys.
  3DVVDORRSHGVWURQJVWULQJ RUORQJWLHEDQG DURXQGWKHPRWRUEUDFNHWDQGSXOOLWZLWKDWHQVLRQJDXJHWRWKH
specified tension. In this condition, uniformly tighten t KHDGMXVWLQJEROWV KH[DJRQVRFNHWKHDGEROWV 0î 
4 pcs.).
8VHDQ$OOHQZUHQFKRIPPDFURVVIODWV 
7LJKWHQLQJWRUTXH 1āFP NJIāFP 
7HQVLRQ NJI
$GMXVWLQJEROWWLJKWHQLQJWRUTXH  
1āFP NJIāFP 
11) Install the pulley cover.
7LJKWHQWKHWKLQKHDGVFUHZV 0îSFV 
XVLQJDQ$OOHQZUHQFKRIPPDFURVVIODWV
7LJKWHQLQJWRUTXH 1āFP  NJIāFP