IAI America RCLE-GR5L - Manual (Page 14)

8
6. This product generates heat. The temperature may get high depending on how
to install it.
Watch out for a burn or injury.
Make sure to follow the instructions below when installing.
Ɣ Install the unit on a material with high heat conductivity.
To prevent a temperature rise on the unit, install it on a material such as metal, which
possesses the characteristic of good heat conductivity. Installing the unit on a material with
insufficient heat conductivity may cause the unit to raise its temperature and may result in a
malfunction.
Ɣ Do not use this product under conditions with bad heat radiation, such as fixing the unit
body on an insulation material or use the unit in a closed area which would not allow heat to
be released. Using this product in a condition with bad heat radiation may cause the unit to
raise its temperature and may result in a malfunction.
Ɣ To block heat from being conducted to the work part, use a material with low heat
conductivity such as polyacetal for the finger attachments.
The heat of the unit is conducted from the fingers to the work part via the finger attachments.
(Reference)
When operated with duty 50%, the temperature rises in approximately 40
qC at the unit
attachment surface (side surface) and finger attachment surfaces.
[Refer to 6.4 Temperature Rises on Main Body and Finger]