IAI America DS-S-C1 - Manual (Page 18)

16
There are two ways to designate the axes to be used: axis number and axis pattern.
7.1 Axis number and notation
With the Super SEL controller, multiple axes are indicated as shown in the table, but it is possible to change the figures
using the parameters.
7. Axis Designation
Axis No.
Default
Notation
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
The axis no. is used when designating one axis out of many axes.
Commands to designate Axis No. are:
BASE, PPUT, PGET
Note: The DS type displays only one axis.