IAI America CT4 - Manual (Page 37)

4. Maintenance Inspection
31
3) Detach the four screws holding the screw cover (at the points where circled) and remove the
screw cover.
Tool to use: Hex Wrench 2.5mm-sized
4) Check inside.
5) After the work is finished, attach the screw cover and tighten the screws.
Tightening Torque : 83N㨯cm
6) Attach the Z-axis cover
Caution: Be careful in case a hand or a work piece is attached and the Z-axis brake is
released. It may cause an injury or may damage the hand or work piece by
dropping it.
4.5 Internal Cleanup
x When cleaning, wipe with a soft cloth to remove dust and dirt.
x Do not blow compressed air so dust would not get in from gaps.
x Do not use oil type solvent, neutral detergent or alcohol.
Screw Cover