IAI America PSEP - Manual (Page 48)

42
/
2.
Wiring
2.4.2 Wiring Layout of FG Terminal Block
FG is to be connected to a screwless terminal block.
Strip the sheath of the applicable wires for 11mm and insert them to the connector. Push a protrusion
beside the cable inlet with a small slotted screwdriver to open the inlet. After inserting a cable, remove
WKHVFUHZGULYHUIURPWKHSURWUXVLRQWR¿[WKHFDEOH
Ɣ )*7HUPLQDO%ORFN
Terminal Block Name FG
Controller Side ML-800-S1H1P
Pin No. Signal Name Contents Applicable Cable
1 FG Ground Cable Connection KIV1.25mm 2 (AWG16)