IntelliTrack Check In/Out - Manual (Page 35)

Chapter 2
Device Setup
25
9. The mapping will appear in the navigation tree, underneath the Key
Macros listing.
10. Click File > Save from the menu bar to save your settings.
11. Click File > Exit from the menu bar to close the termcfg.bin-CFGMgr
screen.
Checking RF Server Settings
Next, make sure you have enabled Telnet-Line Mode support in the RF
Server:
1. Click Start > Programs > IntelliTrack > DMS > RF Server > Check
In-Out RF. The IntelliTrack RF Server application opens on the desk-
top computer.
2. Next, click Options in the menu bar; the Options form appears.
3. Click the Utilities tab to bring this section to the front.
4. Mark the Telnet Mode check box to enable Telnet support.
5. Click the Close button to close this screen and save your changes.
When you restart the IntelliTrack RF Server application, the change
will be enacted.
Checking your Device-PC Connection
To ensure that the RF Telnet settings are sent to the Wavelink application
on the device and that the device is connected to the PC:
1. From the Wavelink Product Configuration Screen, click the Config
Only button. This will ensure that the RF Telnet configuration files are
sent to the device. (If Wavelink is not installed on the device, click the