JuiceGoose iP 1 (Piwi) - Manual (Page 16)

CONSOLE COMMANDS AVAILABLE
Here is a list of the console commands available using UDP and RAW TCP.
POD1ON – Turns POD 1 on
POD1OFF – Turns POD 1 off
POD2ON – Turns POD 2 on
POD2OFF – Turns POD 2 off
ALLON—Turns all PODs on without sequence
ALLOFF – Turns all PODs off without sequence
SEQUP(X) – Sequences up all PODs from 1 to 2, where (X) is the number of
seconds between sequence events (e.g. A 2 second sequence would be SE-
QUP2)
SEQDOWN(X) Sequences down all PODs from 2 to 1, where (X) is the number
of seconds between sequence events (e.g. A 2 second sequence would be
SEQDOWN2)
POD1CURRENT (Reports current draw on Pod 1)
POD2CURRENT (Reports current draw on Pod 2)
DHCPON - Enables DHCP on the iP-1
DHCPOFF - Disables the DHCP on the iP-1. You will want to disable DHCP
before entering any new network settings or the changes will be lost when con-
necting the unit to a network.
SETIP
XXX.XXX.XXX.XXX - Sets the IP address of the unit where ‘X’
represents your chosen numerals.
SETMASK XXX.XXX.XXX.XXX - Sets the subnet mask of the unit
where ‘X’ represents your chosen numerals.
SETGATEIP XXX.XXX.XXX.XXX - Sets the gateway of the unit where
‘X’ represents your chosen numerals.
SETPDNS - Sets the primary DNS IP address.
SETSDNS - Sets the secondary DNS IP address.
INFO - Shows all current settings
RESTART - Restarts/Reboots the iP-1. Use this command after making
your changes.
Page 15