JuiceGoose iP 1 (Piwi) - Manual (Page 4)

DETAIL SPECIFICATIONS
CHASSIS……………………………………….…Metal 3 gang front panel. Two gang back box
DIMENSIONS (inches)……………………………………..….....…...…..4.5”H x 6.5”W x 3.75”D
WEIGHT (lbs)……………………………………………………………..………………………..1.0
AVAILABLE FRONT PLATE AND DUPLEX COLORS …………….....……Black, Tan, White
TECHNICAL CURRENT RATING….…………………………………………………………...12A
RELAY CURRENT RATING…………………………………….……………………………….16A
NUMBER OF CONTROLLABLE PODS………………………………………………………..Two
POWER INPUT.……….....……………..………………………………………………...Hardwired
POWER OUTPUT……………………………………...Single NEMA 5/15R Duplex (Controlled)
VOLTAGE INPUT……………………………….……………………………….120 VAC @ 60 Hz
SIGNAL CONNECTIONS……………………………………………………...…..Ethernet (RJ45)
MONTIOR FEATURES…….………Local LED, Remote Graphical Interface (On/Off, Current)
FRONT PANEL FEATURES
NETWORK LED - This LED will light up solid when the iP-1 is connected to an
Ethernet network connection. It will blink quickly when an Ethernet cable is at-
tached but no network can be found. When no network cable is connected the
light will blink slowly indicating the unit is powered up.
DUPLEX OUTPUT- There is 1 duplex receptacle on the front panel of the iP-1.
This is split into 2 outlets, each is rated for a maximum 15 amp load and each is
controllable to turn on or off independently of the other. When the on-board se-
quencing process is used outlet 1 will turn on first, followed by the 2nd outlet.
They will turn off in reverse order using this same process.
CHASSIS FEATURES
NETWORK (Ethernet) PORT - This RJ45 connector is for connecting to your PC,
router or local area network using a TCP/IP link.
FACTORY RESET SWITCH - This switch located to the right of the RJ45 connec-
tor is used to reset the iP-1 back to factory settings. This process should only be
attempted by a qualified electrician as it requires the unit to be powered during
the reset process. Hold in for 10 seconds under power to reset to factory settings.
Page 3