JuiceGoose iP 1 (Piwi) - Manual (Page 6)

1. Multiple iP-1 setup on a router.
1(a). When installing more than one iP-1 on a router each one needs to be as-
signed it’s individual IP address before plugging/powering on the next unit to be
added.
1(b). Connect the first iP-1’s network cable to the router and follow the singular
unit setup above.
1(c). Be sure to turn off DHCP in the configuration section of the IP-1’s configu-
ration page and assign the IP address you want the unit to use.
1(d) Once the IP address as been assigned click the save button to save and
reboot the iP-1.
1(e) You now access the iP-1 you just configured by using it’s assigned IP ad-
dress rather than the http://juicegoose method.
1(f) Repeat steps (b) through (e) assigning a different IP address for each unit.
1(g) If remote operation of multiple units is desired you’ll also need to choose a
different port number for each unit, the default is port 80.
2. Bench setup.
2(a). Gather all the iP-1s you want to setup along with a computer, crossover
cable and
2. The iP-1 Network LED on the front of the unit should illuminate and remain
on without blinking, indicating network connectivity. If the Network light blinks
check the cable connections.
4. In Windows go to your start menu and navigate to the control panel. Then
choose the Network Connections” icon.
5. Open Network connections by double clicking on it, select the LAN or HIGH-
SPEED icon, right click on this and select properties.
6. Click once on the Internet Protocol item that you will see at the bottom of the
list and select the properties button which is at the mid right.
7. Check the “Use the following IP address” box and then change the IP ad-
dress to: 192.168.1.1, then change the Default Gateway address also to:
192.168.1.1.
8. Click OK and then close the network box.
9. Open a web browser on your PC and type in the following address on the
navigation bar to access the iP-1: 192.168.1.77.
10. The iP-1 login box will appear, enter your login details and operate the iP-1.
Page 5