Upper oven - rst models – Amana RSS User Manual

Page 102

Advertising
background image

UPPER OVEN - RST Models

101

RC231002 Rev. 3

Figure 90

Electric Gas Valve

The operation of the Electric Gas Valve Assembly can be

checked with the use of an incandescent test lamp (105 -

120 V., 7 watt bulb). An optional test procedure for the

Electric Gas Valve Assembly using a Volt/Ohmmeter is

also explained.

Test Procedure Using a Test Lamp:

1.

Disconnect electricity. (Disconnect plug or power

cord.)

2.

Attach one (1) lead of test lamp to any white wire

(except for white wire on gas valve).

3.

Attach the remaining lead of the test lamp to the "RED"

wire on the gas valve (point A).

4.

Set the oven heat control to 350°.

5.

Reconnect electricity.

6.

No light at "RED" wire = electrical circuit interrupted

before gas valve. Light at these terminals, proceed to

Step 7.

7.

Disconnect electricity. Attach lead of test lamp to the

"white" wire terminal on the gas valve (point A).

8.

Reconnect electricity. Set the oven heat control at

350°.

9.

No light at "WHITE" wire = electrical circuit interrupted

in gas valve. Light at "WHITE" wire indicated an

operative gas valve.

Figure 91

Optional Test with Volt/Ohmmeter

1.

Disconnect electricity. (Disconnect plug or power

cord.)

2.

Remove the two (2) wire terminals from the gas valve

(point A).

3.

Set volt/ohmmeter on the X1 ohms scale. (Zero the

meter.)

4.

Attach a meter lead to each of the terminal studs of the

valve.

5.

If the meter does not show an "open" circuit, the gas

valve is operative.

6.

Reattach the two (2) wire terminals removed from the

gas valve (point A).

Clock Timer

The automatic electronic timer is located in the upper oven

control panel (see illustration) and controls bake-broil-self-

clean functions for lower oven. Upper oven is manually

operated by the thermostat knob. Instructions for operating

and testing the clock timer are on Pages 56 - 59. Refer to

RST399 wiring diagram for wiring connections.

FIRE OR EXPLOSION

TO AVOID THE RISK OF ELECTRICAL SHOCK, PERSONAL INJURY OR DEATH DISCONNECT POWER

BEFORE SERVICING, UNLESS TESTING REQUIRES IT.

Advertising
This manual is related to the following products: