Disassembly procedures - rst models – Amana RSS User Manual
Page 99
FIRE OR EXPLOSION - TO AVOID THE RISK OF ELECTRICAL SHOCK, PERSONAL
INJURY, OR DEATH, DISCONNECT POWER TO THE OVEN BEFORE SERVICING.
DISASSEMBLY PROCEDURES - RST MODELS
RC231002 Rev. 3
98
DOOR GLASS - INNER
1.
Remove oven door assembly from the range and
place door on a protected surface.
2.
Remove the six (6) screws securing the oven door
backer to the oven door frame. On Model RST354 the
backer is attached to the outer door frame.
3.
Remove two (2) screws securing heat shield to door
backer.
4.
Remove the fourteen (14) screws securing the door
backer to the sub backer. Gently remove door
backer. NOTE POSITION OF DOOR GASKET FOR
CORRECT REASSEMBLY.
5.
Remove insulation and the eight (8) screws securing
the window assembly to the door backer.
6.
Gently remove window assembly.
7.
Reverse procedure to reinstall.
When reassembling, be sure hinge pins and rubber
bumpers are in place.
Figure 89
OVEN DOOR GLASS - PORCELAIN DOOR
Model RST354
1.
Remove oven door from range and place it on a
protected surface.
2.
Remove six (6) screws securing door backer to outer
door panel and remove panel.
3.
Remove screws securing glass retaining clips to outer
panel and remove glass.
4.
Reverse procedure to reinstall.
STORAGE DRAWER PANEL, STORAGE CDRAWER
BACKER, STORAGE DRAWER, STORAGE DRAWER
TRACKS (RSS MODELS)
1.
Pull storage drawer all the way out - lift up on runner
(gray - left, black - right) arms inside then pull storage
drawer all the way out and off or range.
2.
Tracks are fastended to side frame with a screw.
3.
Runners are fastened to storage drawer by two (2)
pop rivets on each side.
4.
Storage drawer panel and storage drawer backer are
secured to storage drawer using screws.
STORAGE DRAWER PANEL (RST MODELS)
1.
Remove storage drawer from range.
2.
Remove six (6) screws securing outer panel to drawer
panel liner.
3.
To replace the panel, remove four (4) screws secur-
ing drawer handle to panel.
STORAGE DRAWER HANDLE (RST MODELS)
1.
To remove the handle, using the Storage Drawer
Panel Removal Procedure.