Teledyne LeCroy PETracer Summit and Summit T2-16 PCIe User Manual - Manual (Page 71)

Summit User Manual Chapter 4: Software Overview
Teledyne LeCroy
63
4.8 Making a PCI Express Recording
After connecting the Analyzer to the device(s), you must configure the
Recording Options. Then you can test the Analyzer by creating a 16-MB snapshot
recording.
To make this recording, follow these steps:
Step 1 From the Setup menu, select Recording Options.
Step 2 Select the General tab.
The following window displays the factory default settings in Simple Mode, such
as Snapshot and 16-MB buffer size. For your first recording, you can leave these
settings unchanged.
Step 3 In the Link section, specify the lane width of the PCI Express link to be
analyzed. The rest of the settings in this section can be left at the factory
defaults for most PCI Express systems.