Teledyne LeCroy Sierra M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 71)

Sierra M6‐1 SAS/SATA Protocol Analyzer User Manual 69
Trigger Setup Teledyne LeCroy
Define Sequential Trigger Mode
This is enabled when more than one pattern is used. It allows for the use of a simple state
machine of “pattern A then pattern B”. When checked, the Count field in each pattern’s
dialog is enabled (see figure below).
Figure 2.36: Count Field Dialog
The SATA Parameters window displays the following trigger pattern categories:
 Timer
 Timeout
 External/Manual Trigger
 Device Sleep
 Bus Condition
 Symbol
 Primitive
 FIS
 FIS Pattern
 ATA Command
 ATA Command Pattern
 ATAPI
 Soft Reset
 Data Pattern
 Protocol Errors
Note: In packet view, you can right‐click on any frame, select Add to Trigger, and add the pattern to
DataPatternCapture to make it a trigger pattern.
Count field disabled Count field enabled