Teledyne LeCroy Sierra M6-1 SAS_SATA Protocol Analyzer User Manual - Manual (Page 89)

Sierra M6‐1 SAS/SATA Protocol Analyzer User Manual 87
Trigger Setup Teledyne LeCroy
Figure 2.57: SATA: ATA Command Pattern Dialog
Choose an ATA command, and click OK.
Soft Reset (SATA only)
Double‐click Soft Reset to open the Soft Reset dialog.
Figure 2.58: SATA: Soft Reset Dialog
SAS vs. SATA: Not available in SAS.
2.13.8 Sequential Trigger Mode
In Sequential Trigger mode, triggering occurs whenever the system detects a specific
sequence of patterns. Defining the triggering patterns sets the sequence order. You must
define at least two patterns to enable selection of Sequential Trigger mode.
Note: Patterns, such as Primitives and Symbols or Frames, occurring very close together on different
ports can cause false triggers.