Teledyne LeCroy WaveStation SCPI Command Reference Manual - Manual (Page 18)

WaveStation SCPI
Parameters Value Description
MEAN <mean>
Parameter is valid only when WVTP is NOISE. Where <mean>:= {default unit is
V; range depends on <standard deviation>}.
WIDTH <width> Value of width. Parameter is valid only when WVTP is PULSE.
RISE <rise> Value of rise. Parameter is valid only when WVTP is PULSE.
FALL <fall> Value of fall. Parameter is valid only when WVTP is PULSE.
DLY <delay>
Where <delay>:= {default unit is S; minimum 0, maximum is Pulse Period}.
Parameter is valid only when WVTP is PULSE.
QUERY SYNTAX
<channel>:BaSicWaVe?
<channel>:= {C1|C2}
RESPONSE
<channel>:BSWV <type>,<frequency>,<offset>,<amplifier>,<duty>,
<symmetry>,<phase>
EXAMPLE 1 Set Channel 1 basic wave type to Ramp.
C1:BSWV WVTP,RAMP
EXAMPLE 2 Set Channel 1 signal frequency to 2000Hz.
C1:BSWV FRQ,2000HZ
EXAMPLE 3 Retrieve Channel 1 Basic Wave settings.
C1:BSWV?
Return:
C1:BSWV TYPE,SINE,FRQ,1000,AMP,3,OFST,3
RELATED ARWV, BTWV, CFG, CPL, MDWV, SWWV
16 922829 Rev C