Command reference – Teledyne LeCroy WaveStation SCPI Command Reference Manual User Manual
Page 23
Command Reference
Parameters
Value
Description
(PM,)MDSP
<wave shape>
Where PM <wave shape>:= {SINE, SQUARE, TRIANGLE, UPRAMP,
DNRAMP, NOISE, ARB}. Parameter is valid only when PM,SRC is INT.
(PM,)FRQ
<frequency>
Where PM <frequency>:= {WS2000 0.002Hz to 20000Hz; WS3000
0.001Hz to 50000Hz}. Parameter is valid only when PM,SRC is INT.
(PM,)DEVI
<phase offset>
Where PM <phase offset>:= {0 to 360}. Parameter is valid only when
PM,SRC is INT.
(PWM,)FRQ
<frequency>
Where pulse wave < frequency>:= {0Hz to 4kHz}. Parameter is valid only
when CARR,WVTP is PULSE.
(PWM,)DEVI
<duty cycle
deviation>
Where pulse wave <duty cycle deviation>:= {depends on carrier waveform
duty cycle}. Parameter is valid only when CARR,WVTP is PULSE.
(PWM,)MDSP
<wave shape>
Where pulse <wave shape>:= {SINE, SQUARE, TRIANGLE, UPRAMP,
DNRAMP, NOISE, ARB}. Parameter is valid only when CARR,WVTP is
PULSE.
(PWM,)SRC
{INT|EXT}
Sets pulse wave signal source to INTernal or EXTernal.
(ASK,)SRC
{INT|EXT}
Sets ASK signal source to INTernal or EXTernal.
(ASK,)KFRQ
<ASK key
frequency>
Where <ASK key frequency>:= {WS2000 0.002Hz to 20000Hz; WS3000
0.001Hz to 1MHz}. Parameter is valid only when ASK,SRC is INT.
(FSK,)KFRQ
<key frequency>
Where FSK <key frequency>:= {WS2000 0.002Hz to 50000Hz; WS3000
0.001Hz to 1MHz}. Parameter is valid only when FSK,SRC is INT.
(FSK,)HFRQ
<hop frequency>
Where FSK <hop frequency>:= {same as basic waveform frequency}.
(FSK,)SRC
{INT|EXT}
Sets FSK signal source to INTernal or EXTernal.
(CARR,)WVTP
<wave type>
Where carrier <wave type>:= {SINE, SQUARE, RAMP, ARB, PULSE}.
(CARR,)FRQ
<frequency>
Where carrier wave <frequency>:= {default unit is Hz; minimum value is
1xe-6 Hz, maximum value depends on the WaveStation model}.
(CARR,)AMP
<amplifier>
Where carrier wave <amplifier>:= {default unit is V; Channel 1 minimum
0.004V, maximum 6V; Channel 2 minimum 0.004V, maximum is 20V).
(CARR,)OFST
<offset>
Where carrier wave <offset>:= {default unit is V}.
(CARR,)SYM
<symmetry>
Where carrier wave <symmetry>:= {0% to 100%}.
(CARR,)DUTY
<duty cycle>
Where carrier wave <duty cycle>:= {if CARR,WVTP is SQUARE, 20% to
80%; if CARR,WVTP is PULSE, 0.1% to 99.9%}.
(CARR,)PHSE
<phase>
Where carrier wave <phase>:= {0 to 360}.
(CARR,)RISE
<rise>
Value of rise.
(CARR,)FALL
<fall>
Value of fall.
(CARR,)DLY
<delay>
Value of delay.
922829 Rev C
21