Vanguard CT-3500 - Manual (Page 17)

Model CT-3500

Operating Procedures
13
c. Press ENTER key to advance to the next
display (i.e., second-stroke bounce time).
d. Press ENTER key to advance to the next
three-phase timing result display (i.e.,
CONTACT LIVE TIME—see below).
5.6 Review Shot Procedure
This procedure describes steps to review a
test record residing in CT-3500 working
memory. The user can view the record on
the LCD display or from a thermal printout.
NOTE
To review a test record stored in Flash
EEPROM, the user must first restore test
record from Flash EEPROM to working
memory (see paragraph 5.7)
The Restore Recording Procedure steps
begin at the Set-Up Menu, shown below:
SET-UP MENU
a. Press key #2 (REVIEW SHOT) to begin
the Review-Shot procedure. The following
menu displays:
b. Press key 1 to display shot identification
and key-in number of shot to be reviewed
(default is last timing shot). The display
will show the shot record number (just
selected), the type of shot (OPEN, CLOSE,
OPEN-CLOSE, or CLOSE-OPEN), and the
date and time of the selected shot (shown in
the second display below)—go to the next
step.
Press key # 2 (PRINT DATA) to print out
all the timing data on the selected shot
record, during which the advisory DISPLAY
IS shown below.
After printing, the display returns to the
START-UP MENU, thus ending the Review
Shot procedure).
c. When the shot record of interest displays
(see b.), press ENTER to begin the timing
review sequence (virtually the same display
sequence that displayed during the original
timing shot—refer to section 5.5), after
which the display returns to the START-UP
Menu. This ends the Review Data
procedure.
OPEN BOUNCE TIME
A 00.00mS 0.00CY
B 04.20mS 0.25CY
C 00.40mS 0.02CY
CONTACT LIVE TIME
A 1460.90mS 87.65CY
B 1454.30mS 87.25CY
C 1459.70mS 87.58CY
1. ENTER ID
2. REVIEW SHOT
3. RESTORE SHOT
4. NEXT PAGE
REVIEW TEST
1. DISPLAY TEST DATA
2. PRINT TEST DATA
PRINTING REPORT
PLEASE WAIT…
SHOT 01
OPEN SHOT
05/15/01 10:28:03