Vanguard CT-3500 - Manual (Page 20)

Model CT-3500

Operating Procedures
16
5.9 Computer Interface Procedure
The CT-3500 can store up to 128 timing
records in the FLASH EEPROM. These test
reports can be transferred through the RS-
232C port. A window software package
provided with the CT-3500 allows the user
to transfer test report to the IBM PC.
Use the following steps to put the CT-3500
under computer interface mode:
a. Accordingly, Press key #2 (SETUP) on
the Start-Up Menu, which will produce the
SET-UP MENU (shown below):
SET-UP MENU
b. Press key # 4 NEXT PAGE) to display
the following options menu:
c. Press Key # 1 (COMPUTER
CONTROL) to control the CT-3500 from a
remote IBM-compatible PC. The computer
interface (ITF) mode advisory displays
(shown below): go to the next step
d. From this point on (for as long as this
screen displays, the CT-3500 is controlled
by the PC. To end the Computer Interface
mode, press the STOP key, at which time
the display will return to the START-UP
MENU (section 5.4).
5.10 Set Date and Time
The date and time setting begins at the Set-
Up Menu, shown below:
a. Begin at the START-UP MENU: Press
key #2 (SETUP) to display the SET-UP
MENU shown below:
SET-UP MENU
b. Press key #4 (NEXT PAGE) to display
the menu shown below:
c. Press key # 2 (SET TIME) to display the
prompt to enter the present date and time
(shown below):
NOTE
In the above prompt: MM = month,
DD = day, YY = year, and HH = hour,
MM = minute, SS=seconds.
d. Set the date (month, day, year) with six
key presses for the above prompt; Set the
time (hour, minute, second) with six key
presses. When date and time are set, the
screen will return to the START-UP MENU.
This completes set date/time procedure.
5.11 Set 50/60 Hz Procedure
The test result of the CT-3500 display in
millisecond and cycles. The user can select
either 50Hz or 60Hz cycle mode on the test
results.
1. ENTER ID
2. REVIEW SHOT
3. RESTORE SHOT
4. NEXT PAGE
1. ENTER ID
2. REVIEW SHOT
3. RESTORE SHOT
4. NEXT PAGE
1. COMPUTER CONTROL
2. SET TIME
3. SET 50/60 Hz
COMPUTER ITF MODE
1. COMPUTER CONTROL
2. SET TIME
3. SET 50/60 Hz
ENTER
MM-DD-YY HH:MM:SS