Vanguard CT-3500 - Manual (Page 18)

Model CT-3500

Operating Procedures
14
5.7 Restore Shot Procedure
This procedure allows the user to restore a
test record from the CT-3500 Flash
EEPROM to working memory. The user
then can review the test record using the
REVIEW RECORD command (5.6).
The Restore Recording Procedure steps
begin at the Set-Up Menu, shown below:
SET-UP MENU
a. Press key #3 (RESTORE SHOT) to
begin the Restore-Shot procedure. The
following menu displays:
b. Press key # 1 to select the Restore Shot
function: this displays the RESTORE SHOT
menu (shown below).
c. If the number of the shot to be restored
is known, press key number 1(ENTER
SHOT NUMBER) and go to next step; if the
number of the shot to be restored is not
known, press key number 2 (SCROLL TO
SELECT) and skip forward to step e.
d. Key in the number of the shot to be
restored and press ENTER: “Shot Restored”
displays (see below) after which the
REVIEW DATA sequence begins (go back
to step b of section 5.6 to continue the
RESTORE SHOT procedure to conclusion).
e. The SCROLL TO SELECT (option 2
back in step c) an instructional prompt
displays (see below):
Use the UP (? ) and DOWN (? ) keys to
scroll through the saved shot records until
the shot record of interest displays, and then
press ENTER. Then the REVIEW DATA
sequence begins (go back to step b of
section 5.6 and continue the RESTORE
SHOT procedure to conclusion, after which
the START-UP MENU displays).
This ends the RESTORE SHOT procedure.
1. ENTER ID
2. REVIEW SHOT
3. RESTORE SHOT
4. NEXT PAGE
1. RESTORE SHOT
2. DIRECTORY
3. ERASE SHOT
4. (RE)SAVE SHOT
RESTORE SHOT
1. ENTER SHOT NUMBER
2. SCROLL TO SELECT
RESTORE SHOT
NUMBER: 1
SHOT RESTORED!
SHOT DIRECTORY
“UP” TO SCROLL FWD
“DWN” TO SCROLL RVS
#01 08/15/01 10:28:03
OPEN SHOT