Vanguard CT-7000 S3 - Manual (Page 31)

REV 1 CT-7000 S3 USER’S MANUAL
26
3.2.4. Setting the Units of Measure
The CT-7000 S3 supports and displays both English and Metric calculations. You can switch
between the English and Metric systems using the steps below:
a. Start from the “START-UP” menu:
Press the
[4]
key (SETUP).
b. The following screen will be displayed:
Press the [2] key (MEASUREMENT UNITS).
c. The following screen will be displayed:
Press the [1] key (ENGLISH) or the [2] key (METRIC) to select the corresponding
measurement system. The measurement system will be set and you will be returned to
the “START-UP” menu.
NOTE
If the measurement system is changed, any relevant values in the working
memory will be automatically converted to the new system. Also, if retrieving
a test record from the Flash EEPROM, all data will be converted to the new
measurement system. There is no need to re-run a test.
SELECT UNITS:
1. ENGLISH
2. METRIC
3. ROTARY ENCODER
4. RES ENCODER
1. ANALYSIS POINTS
2. MEASUREMENT UNITS
3. SHOT DESCRIPTION
4. NUMBER OF CHANNELS
5. NEXT PAGE
1. TIME BREAKER 09/12/13
2. GET RESULTS 10:10:10
3. SAVE/RESTORE
4. SETUP
5. DIAGNOSTICS