Vanguard EZCT-2000 - Manual (Page 38)

EZCT-2000 USER’S MANUAL REV 3
34
3.5.2. Printing a Directory of Test Plans Stored in the EZCT-2000’s Memory
You can print a directory of all the test plans stored in the EZCT-2000’s Flash EEPROM using the
steps below:
a. Start from the “START-UP” menu:
Press the
[3]
key (TEST PLANS).
b. The following screen will be displayed:
Press the [3] key (PLAN DIRECTORY).
c. The following screen will be displayed while the test plan directory is printed on the
thermal printer:
You will be automatically returned to the “START-UP” menu after the directory printing
is finished. A typical Flash EEPROM test plan directory printout is shown in Figure 10.
PRINTING DIRECTORY
1. LOAD TEST PLAN
2. UNLOAD TEST PLAN
3. PLAN DIRECTORY
4. NEXT PAGE
1. RUN TEST 09/24/09
2. SETUP 08:20:19
3. TEST PLANS
4. DIAGNOSTIC