Vanguard EZCT-2000 User Manual
Page 45
REV 3 EZCT-2000 USER’S MANUAL
41
3.5.6. Running a Test Using a Loaded Test Plan
Once a test plan has been loaded into the working memory (see section 3.5.5 for directions), it
can be used to run a test. To run a test using a loaded test plan:
a. Make sure a test plan has been loaded into the working memory and then start from the
“START-UP” menu:
Press the
[1]
key (RUN TEST).
b. The following screen will be displayed (this screen will only be displayed if a test plan
has been loaded first):
1. RUN WITH PROMPTS
Press the
[1]
key to run the test with prompts. Continue to step c.
2. RUN AUTONOMOUSLY
Press the
[2]
key to run the test autonomously. The following screen will be
displayed:
Press the
[START]
key and the EZCT-2000 will start running the test per the
test plan settings. The screen will be updated with the test status.
When the test has finished, the following screen will be displayed:
Press the
[1]
key (YES) to save the record.
The following screen will be displayed momentarily:
SAVE THIS RECORD?
1.YES
2.NO
CABLES WILL BE
ENERGIZED!
“START” TO BEGIN
TEST PLAN LOADED
1.
RUN WITH PROMPTS
2.
RUN AUTONOMOUSLY
3.
UNLOAD TEST PLAN
1.
RUN TEST 09/24/09
2.
SETUP 08:20:19
3.
TEST PLANS
4.
DIAGNOSTIC