ZOLL E Series Monitor Defibrillator Rev M - Manual (Page 34)

Chapter 2 Configuration Parameters
28 9650-1201-01 Rev. M
Pace Parameters
The Pace parameters are attributes that control functions related to performing pacing with an
E Series unit and include:
• Pace Rate Setting on Power Up
• Async Softkey in Pace Mode
Pace Rate Setting on Power Up
This parameter allows you to set the default pace rate, pulses per minute (ppm), of the E Series
unit at power-on.
Values are as follows:
Async Softkey in Pace Mode
This parameter allows you to set the unit to display the Async Pacing On/Off softkey when the
unit is in pace mode. For information about Asynchronous Pacing, refer to the E Series
Operator’s Guide.
Values are as follows:
Possible Values: 30 ppm to 102 ppm (inclusive in increments of 4 ppm)
Default: 70 ppm
Possible Values: Yes, No
Default: Yes